WATERWICH DC12V Voltmeter Blue Digital LED Volt Gauge Voltage Meter Kit 2inches 52mm for Car Truck Vehicle Automotive
$18.99
Rated 4.4 out of 5 based on 76 customer ratings
76 ratingsSource: Amazon
Confirm quantity, package contents, selected variation, current offer details, and store terms before placing the order.
About this item
- 1.Easily display at night:Our volt gauge is highly visible with a BLUE Light,easy viewing at all angles during any lighting conditions,practically and safely when driving at night
- 2.WATERWICH Read Range:Our voltmeter gauge accurately measure the output voltage of the vehicle electrical system between 8 – 18 volts. Please ensure that the voltage is higher than 6.7 volts to light up the instrument. When the voltage is lower than 11.5 volts, the red warning lamp will light up
- 3.LED displays provide precise reference to critical operating conditions and alert driver of potentially damaging operating conditions,simple to install and direct replacement
- 4.Our gauge kit includes: instrument,harness and instruction,High sensitivity and Easy installation:Our gauge includes electric wire with necessary mounting and installation hardware,no need other sensor
- 5.Used to monitor the storage-battery voltage,Timely grasp the state of your battery between full charged and discharged,Power supply: DC12V 0.3A (maximum),Diameter 2 “52mm automobile universal digital Volt meter,Wide Compatibility for Car,SUV,Truck,Vehicle Automotive etc
Before you order
- Confirm the part number, position, dimensions, and connector details shown on this page.
- Compare the listing with the part currently installed on your vehicle.
Chad –
Imported from Amazon. This is not a review of a purchase made on this website.
External marketplace context: Verified Purchase
Works as it shouldNice and bright
R. Meyer –
Imported from Amazon. This is not a review of a purchase made on this website.
External marketplace context: Verified Purchase
Wanted a basic voltmeter that fit into a 2″ knock-out. Many panel voltmeters listed on Amazon are much smaller in size. Not much of a problem if you’re making your own mounting hole, but if you are using an existing gauge hole, then size obviously matters.Highlights: Easy to install with a threaded ring on the back side of the gauge. Included cable with connector (gauge end) is appropriate in length. Easy to read in daylight, so it’s suitable for outdoor power equipment.Weaknesses: There’s no way to dim the display, so it’s obnoxiously bright at night. The red low voltage warning indicator is probably the dimmest LED in the display. The continuously lit “Warning” label is brighter. Accuracy is not superb, but it’s likely acceptable for most applications. It seemed to measure within 10% when compared to a high-quality voltmeter (Fluke). Response time was a bit slow, but possibly this is due to capacitive filtering within the gauge to remove voltage spikes oftentimes present on small engine charging systems.Wishes: Add a dimmer signal input that can be coupled to the dashboard light system so brightness roughly follows dashboard lighting. Or, at the very least, add an ambient light sensor to dim the display in dark conditions. Get rid of the little red warning LED and just make the word “WARNING” flash, with a bright red LED when the voltage is determined to be below nominal levels.
The Barns LLC –
Imported from Amazon. This is not a review of a purchase made on this website.
External marketplace context: Verified Purchase
As described
richard n. –
Imported from Amazon. This is not a review of a purchase made on this website.
External marketplace context: Verified Purchase
this is very bright.i can read it from across the room.i bought this to monitor my solar battery.it might be too bright for nighttime car use.theres no way to dim it.
Rocky –
Imported from Amazon. This is not a review of a purchase made on this website.
External marketplace context: Verified Purchase
Used them on antique tractor instead of original guages Function well
Daniel M. –
Imported from Amazon. This is not a review of a purchase made on this website.
External marketplace context: Verified Purchase
My harley volt meter looked like it was putting out 15-16 volts. With only 2) 1/4”male spade connectors needed, I took out the Harley guage, put this one in and when riding, it held steady at 14.0 and 13.8 at idle. It bounces .2 volts occasionally but well worth it! Now I feel comfortable with the charging system. The numbers are dark blue- a little hard to see in the direct sun but for piece of mind- it’s worth it. It also has a red warning symbol if it should overcharge 👍🏻The harley light bulb wasn’t needed.
joel –
Imported from Amazon. This is not a review of a purchase made on this website.
External marketplace context: Verified Purchase
Put it in my derby car, works as it should!
Big Tater –
Imported from Amazon. This is not a review of a purchase made on this website.
External marketplace context: Verified Purchase
Had it two months and it stopped working. Waste of money. Lesson learned