525019 RV Furnace Replacement Parts for Suburban Igniter Electrode Ignition Switch RV Furnace Igniter NT Series NT-30SP Electronic Ignition NT-34SP Furnace Electrode 230956 Ignitor Module 1 Pack
$19.89
Rated 5 out of 5 based on 6 customer ratings
6 ratingsSource: Amazon
Confirm quantity, package contents, selected variation, current offer details, and store terms before placing the order.
- Package of Suburban RV Furnace Parts: Suburban furnace igniter is also known as suburban ELECTRODE, total 1 piece suburban ignition switch for suburban furnace parts (Please make sure the suburban stove igniter replacement parts perfectly fit your suburban stove parts)
- Material of Suburban Igniter: The suburban nt-30sp furnace parts is made of upgraded ceramic and metal, giving the suburban oven parts more durable, heat-resistant, perfect match, easy install and long-lasting, provide a seamless cooking experience
- 【Suburban RV Stove Parts Number】 Suburban 525019, 230956 and more. 【Compatible with Rv Suburban Furnace Parts】 Suburban P-30S, P-40S, NT-30, NT-34, NT-24, NT-30S, NT-34S, NT-24S, NT-34S, NT-30SP, NT-34SP, NT-24SP, NT-30SP, NT-34SP and more, suburban nt-30sp furnace parts, suburban rv furnace nt-30sp parts, nt-30sp furnace parts, 525019, 230956, suburban rv heater nt 30sp parts, 230956 suburban electrode
- Excellent Design: Suburban furnace igniter is a electrode spark igniter, electricity sparks the burners in suburban rv parts with electronic ignition. suburban furnace electrode provide the spark that ignites the gas when the knobs is turned on. This spark ignites the gas, creating a controlled flame for cooking
- Easy to Install: The suburban ignition module is easy to install that position the new ignitor in place, just like the old one. Took a few minutes and the suburban rv furnace ignition module will work well. Please handle the suburban rv cooktop parts carefully, suburban rv furnace parts is fragile, and if it chips or cracks, you can’t use it
- Notice: Ensure that the suburban rv furnace is turned off and has cooled down before starting the removal process. This will prevent any accidental burns or injuries. If you are unable to confirm that the suburban furnace parts is compatible with your range, please do not hesitate to contact us
Before you order
- Confirm the part number, position, dimensions, and connector details shown on this page.
- Compare the listing with the part currently installed on your vehicle.
Richard –
Imported from Amazon. This is not a review of a purchase made on this website.
External marketplace context: Verified Purchase
Fits the Suburban NT-30SP RV furnace manufactured in 1989.It does not come with a high heat resistant gasket. Try to remove the old one intact. Otherwise as I did. I ordered sheet high heat gasket material and made a new one. You must have a good gasket to prevent a CO leak into the coach.This new probe set comes with the spark gap of 1/8 inch which is stated in the service manual to be correct. Tested and confirmed the spark gap is correct. Wire connections fit the OEM connectors. Once installed use a volt meter set to measure Ohms. Confirm the ground probe has a resistance is zero ohms to the furnace chassis and circuit ground.If you get no spark function. Check the thermal limit disc switch on the heat exchanger box. The contacts should be near zero Ohms. Then confirm the fan sail switch is mechcanically functioning and when the switch is actuated there is less than 1/2 ohm. Without the 12 vdc passing through these two limit switches, the control board will not go into an ignition mode. If the limit switches are operation correctly then there is likely an issue with the control board spark coil circuit. The board often will have to be replaced.
Racquel Reser –
Imported from Amazon. This is not a review of a purchase made on this website.
External marketplace context: Verified Purchase
Perfect fit