Transmission Filter Service Kit with Replacement Filter and Pan for Land Rover LR3, LR4, Range Rover Sport and Full Size, Easier Install Process
$154.95
Rated 5 out of 5 based on 17 customer ratings
17 ratingsSource: Amazon
Confirm quantity, package contents, selected variation, current offer details, and store terms before placing the order.
- [FITS] – This transmission filter service kit is for Land Rover LR3 (2005-2009), LR4 V8 5.0L (2010-2013), Range Rover Full Size/Full Size Supercharged (2006-2012) and Range Rover Sport/Sport Supercharged (2006-2013).
- [NOTE] – A great upgraded solution that actually makes your ZF Rover transmission fluid change much easier to complete than using typical OE Land Rover process. IMPORTANT: Before installing bolts, the bolt holes must be cleaned using an M6 tap to remove any corrosion or debris and to ensure new bolts get proper thread engagement.
- [PRO TIP] – Worn transmission fluid leads to judder, noise and a deterioration in gear change quality. ZF recommends oil and filter changes after 50,000 to 75,000 miles on all 5, 6 & 8-speed automatic gearboxes, to ensure optimum performance
- [INSTALLATION] – Once the fluid has been drained from the transmission, simply remove the bolts from the old unit and cut the old plastic sumps filter tube with a hacksaw. Slide the old sump out and remove the other end of the sawn-off filter tube. The new separate filter can then be fitted and the new sump pan slides into place and is bolted up with the new gasket supplied
- [QUALITY] – High-quality design and manufacturing means long lasting durability and performance.
Before you order
- Confirm the part number, position, dimensions, and connector details shown on this page.
- Compare the listing with the part currently installed on your vehicle.
No –
Imported from Amazon. This is not a review of a purchase made on this website.
External marketplace context: Verified Purchase
I don’t usually take photos or videos when I’m working on my car, so sorry no photos of the replacement. But great steel trans pan, shorter 6mm I think hex head bolts a thick cardboard like gasket, although it is not suggested use the gasket spray to stick it to the trans pan, and make sure when you insert the new trans pan to put the front of the pan over the crossmember and then twist and spin the rear of the pan over, I’d would also suggest inserting (if doing it laying on ground) do the front and rear bolts first!
saw dah –
Imported from Amazon. This is not a review of a purchase made on this website.
External marketplace context: Verified Purchase
Overall very good product. Gasket is A little bit off and as the seller said use m-6 tap to clean the screws treat. If seller provides the m-6 tap will be perfect.
Roger –
Imported from Amazon. This is not a review of a purchase made on this website.
External marketplace context: Verified Purchase
If you are going to be doing a replacement of the filter then this is a must. It reduces soo much work and was good quality and perfect fit
Detsy Donohue –
Imported from Amazon. This is not a review of a purchase made on this website.
External marketplace context: Verified Purchase
I replaced my pan with a cheaper plastic pan and it leaked this one doesn’t
VILLA AUTO LLC –
Imported from Amazon. This is not a review of a purchase made on this website.
External marketplace context: Verified Purchase
GOOD PRODUCT
Elizabeth –
Imported from Amazon. This is not a review of a purchase made on this website.
External marketplace context: Verified Purchase
Nice quality upgrade